Bringing mash pH down without changing mineral profile too far

I checked the pH in my mash at the end of my mash yesterday and it was 6.6 (using a calibrated electronic meter). I'm trying to work out how to get that down into a more normal range without adding so much salt that it throws the water profile off the charts. I measured my water without any additions, and it read 7.2.

I had my water tested by [Ward Labs][2] last year:

  • pH 7.4
  • Sodium, Na 10
  • Potassium, K 1
  • Calcium, Ca 46
  • Magnesium, Mg 11
  • Total Hardness, CaCO3 161
  • Nitrate, NO3-N 1.3 (SAFE)
  • Sulfate, SO4-S 6
  • Chloride, Cl 14
  • Carbonate, CO3 1
  • Bicarbonate, HCO3 146
  • Total Alkalinity, CaCO3 120
  • Total Iron, Fe 0.01

I'm using the EZWaterCalculator spreadsheet. Recipe is a 7 gallon mash, 7# of 2-row, 10# of wheat malt, 1# of carapils, 1# of aromatic.

According to the calculator, estimated mash pH is 5.94. I can get that down around 5.6 by adjusting the Gypsum, Calcium Chloride and Epsom Salt, but I have to add so much that the ions in the water profile go way, way over the recommended ranges. And that's still quite a bit lower than the actual reading of the wort.

Do I have other good options for acidifying my mash and staying within my water profile? Are there other calculators out there that will take them into account?

Topic mash-ph water mash homebrew

Category Mac

1
answered at

I use either lactic or phosphoric acid to reduce pH. You can also use acid malt. I think the absolute best water calculator around is Bru'nwater (https://sites.google.com/site/brunwater/). Its author, Martin Brungard, is a professional water engineer who has done work for many large breweries, including Sierra Nevada. It also has a great section on water knowledge.

1
answered at

Keep your water profile basically the same and add acid. You can use many online calculators, but I think its better to deal with it practically. Start your mash and measure pH, then slow add acid a ml or drop wise, remeasuring as you go. Keep track of how much you add, then you have a good starting point to begin with for the next mash.

I'd also measure your starting water without the mash. Once you get a sense of how much acid it took to titrate the mash down to 5.4, you can start acidifying your water before you even dough in. That way your brew day will be a simple function of acidifying the brewing liquor and mashing in. You should be able to hit it right every time.

Of course you'll have to learn how to account for darker malts if you shoot for a different style of beer.

About

Geeks Mental is a community that publishes articles and tutorials about Web, Android, Data Science, new techniques and Linux security.