Can I use my CO2 regulator as a inside keg pressure checker?

Question

Can I use my CO2 regulator as a inside keg pressure checker?

jards

2017年1月23日 11:24

If I force carbonate my keg, and after that I close my CO2 cilinder valve and plug my gas line into my gas in quick disconnect. Would this make my CO2 regulator to work as a spunding valve and let me regulate the CO2 pressure inside my keg? This things works in both flow ways?

If not, there is a way to properly measure the psi inside the keg without buying a pressure gauge for that? That's my plan on future, but for now I need to force carbonate (fast way) a keg, but don't want to take much time in trial and error when go dispensing my beer to get a perfect pouring. There is about 6 hours to my event, not enough time to the 'set it and forget' method. My kegs are pin lock, and doesn't have a pressure relief valve, what makes adjusting pressure when serving a little more difficult.

Topic force-carbonation pressure corny-keg homebrew

Category Mac

Pale Ale · Accepted Answer · 2017年1月23日 11:24

1

Pale Ale answered at 2017年1月23日 11:24

Go over to homebrew finds look up spunding valve, he has all of the parts needed to build one. 25 bucks or so.

skyking · Accepted Answer · 2017年1月17日 06:41

As far as I understand the operation of a pressure regulator it works basically the opposite way of a spunding valve. While the spunding valve opens when the preset pressure is exceeded the pressure regulator closes.

That is if the pressure in your keg is lower than the preset pressure the regulator will open, letting the CO2 from the cylinder into your keg. When the keg reaches the preset pressure it will close and no more CO2 will flow into your keg.

This mean that if there's nothing preventing the pressure to escape and your keg is below the preset pressure the regulator would evacuate CO2 from your keg.

To avoid this you should make sure that CO2 can't be evacuated from the keg by either:

Connect the regulator to the cylinder (but keep the cylinder closed)
Preset the regulator to a pressure lower than that of the keg
Have a double stage regulator (the first stage work as a spunding valve of the cylinder)
Have a regulator that has a built in counter flow valve^*

Also note that after closing the cylinder there will still be CO2 in the high pressure part of the regulator. If your keg is full this gas can contribute significantly to the pressure of the keg (if the preset pressure is higher than that in the keg). In that case you would need to evacuate that part, either by using the relief valve or disconnecting the regulator from the cylinder and connect it again.

_{* This could work to or against your advantage. If the counter flow valve is placed between the keg and the gauge there would be no flow of CO2 from the keg to the gauge and the gauge would be able not measure the gauge of the keg. However I find this construct unlikely.}

FishesCycle · Accepted Answer · 2014年11月5日 14:52

1

FishesCycle answered at 2014年11月5日 14:52

The regulator will give you a reading of the pressure inside the keg, but will not release the pressure the way a spunding valve would -- you'll have to do that manually.

Can I use my CO2 regulator as a inside keg pressure checker?

About