For less than around 2 pounds of milled grain in a nylon bag, do you need an elaborate sparging process?
Do you need much of the equipment for an all-grain setup, or can you basically just soak the grain in fresh water for a few minutes and then add that to the boil?
Topic sparge partial-mash extract-plus-grains grain beer homebrew
Category Mac
I do relatively small batches of grain on the hob (up to 2.5Kg) using a mashing and sparging bag. I have 2 stockpots, one of which is used for the mash, and the second which I half-fill with water near the end of the mash period, and heat to 80 deg C. When the mash is complete I sparge by lifting the bag from one pot to the other. It then sits in the other pot for 10-20 minutes or so before removing. I sometimes support the mash bag above the pot while the remaining wort runs out, but as often as not the bag gets put in a big mixing bowl while I add the sparge wort to the 1st volume of wort.
I started with the full AG kit, I did not realised that all I really needed was a thermometer and a mashing bag, and some kitchen pots.
When I did partial-mash batches, I usually placed the bag of grain in a mesh strainer above my brew pot and poured my sparge water over the bag. It helps to find a strainer wide enough so that it's handles rest on the rim of your pot, otherwise you'll need a brave friend to hold it while you pour your sparge water.
I've done all of the following in extract + grains brewing with 1 - 4 lbs of grain and I can honestly say I've never noticed a difference in the final product:
Geeks Mental is a community that publishes articles and tutorials about Web, Android, Data Science, new techniques and Linux security.