No bubbles in the airlock - should I still bottle the brew?

Question

No bubbles in the airlock - should I still bottle the brew?

Mark McDonald

2011年1月19日 15:47

I'm attempting my first brew using a kit with all the provided ingredients (it's a lager). My brew is still in the big tub and has been there for about 2 weeks now. Initial SG was 1.040 and it's now 1.010.

The problem is that the airlock has never bubbled so I'm not sure if I should proceed to bottling yet or not. I've kept the brew at about 26°C during the day, down to about 22 at night so I think the temperature is OK.

Should I proceed to bottling the brew anyway? Should I add more yeast? Or should I throw it all away and start again? Is there anything else I can test?

[EDIT: updated the initial SG from 1.004 to 1.040, typo sorry!]

Topic first-time airlock primary-fermentation yeast homebrew

Category Mac

Bullet86 · Accepted Answer · 2011年1月19日 15:47

1

Bullet86 answered at 2011年1月19日 15:47

I would also check your fermentation setup. The first batch I did I did not notice any activity in my airlock, turned out that the lid had not been seated 100%and co2 was leaking out of the lid instead of the airlock.

Denny Conn · Accepted Answer · 2011年1月15日 16:44

Yeah, the fermentation temp was way too high. Bubbles don't really tell you much. It's the gravity that matters. I'd say at 1.010 you're done and ready to bottle, but that depends on your recipe and the style of beer, also.

brewchez · Accepted Answer · 2011年1月15日 15:50

1

brewchez answered at 2011年1月15日 15:50

26C is about 79F. That is way too hot. I bet the brew finished while you were sleeping on the first night. Its ready to bottle, so go for it.

baka · Accepted Answer · 2011年1月15日 13:51

Assuming that your 1.004 was a typo, and you meant 1.040, you've gotten around 75% apparent attenuation, so the yeast are probably finished, and you should be able to bottle.

Unfortunately, 26C is about 16C too warm for a lager, so you may have an odd tasting lager. It won't necessarily taste bad, but it won't match the style that you were attempting.

Nick · Accepted Answer · 2011年1月15日 07:39

If the specific gravity has gone up, the beer has not fermented. I recommend taking a sanitized spoon, getting a bit of the wort, and tasting it. If it tastes sour or bad, throw it out. If it tastes sweet, put a new packet of yeast in it and try again. If all goes well, the wort should start bubbling about a day after you add the yeast, and bubble vigorously for a few days after that.

1.004 seems extremely low for an initial SG. Make sure you're reading the hydrometer correctly, correcting for temperature if necessary.

Good luck! Hope this ends tastily!

No bubbles in the airlock - should I still bottle the brew?

About