When using a drill whip to degas, how do I ensure I will not aerate the wine/mead?

I've had meads that have suffered from oxidation and have turned for the worse. I believed this to be at least partially at fault of using a drill whip to degas. After doing more research and experimentation, I've decided that the best method to degas my wines & meads is to actually use a vacuum. I've had successful results of using a foodsaver to degas, similar to what is seen here in this video.

My advice to anyone trying this is to take one of your bungs, and make a custom fit from the vacuum. I used hot glue to the bung, and it creates a air tight seal.

The oxidation in wine you get from vigorous degassing is minimal compared to beer, and those flavors are actually beneficial.

The cardboard or paper flavors that brewers fear from post fermentation oxidation are a result melanoidin based molecules. Melanoidins are very low in wine.

They sell those wine whips that attach to a drill for a reason. Whip away and get that gas out. The out serious out gassing will also counter act some of the O2 pick up.

I make wine as well as beer, and whipping it into a frothy mess is not a problem for the wine. In fact, you need to get the gas out to help ensure clarity steps further down the road. We also add sulfite base stabilizers to wine which helps with oxidation.

I'd recommend strongly that you use your wine whip with you fermentor either in a larger sink or place in on a couple old towels. The wine will foam over if you are in a 6 gallon carboy with 5 gallons of wine.

You should be agitating the wine or mead without sloshing it. The agitation happens under the surface, which causes the co2 to be released. There should be little or no motion on the surface, and certainly no splashing.

This next point is a bit controversial - for mead, don't worry about oxidization - the oxidization of honey is apparently actually flavorful, according to Moonlight Meadery